Place the glue stick in the glue gun, then pull the trigger and start the power supply, preheat for 5 minutes. Larger pits require one Corresponding larger adhesive adapter (note: the larger the pit, the greater the tensile force) 4. Press the trigger to stroke the pressed adhesive on the adhesive adapter.
Place the adhesive adapter with hot glue in the recess as fast as possible, keep it until the glue sticks firmly. (Allow the glue to cool for about 8 minutes, the cooling time should be less than 10 minutes, in winter it should be even shorter) 6. T-repair device aligns with the adhesive adapter (with hot glue), pulls back the slider (sliding) and pulls out the dent. Check with the reflector board (bulge shield) if the dent still exists, Please knock easily with a denting hammer or denting pin. Clean the already repaired place with clean cloth and alcohol.Consists 10x bulge (bulge) 1x delta lifter 1x slide hammer 1x glue gun 1x pull-bridge 1x Ausbeulschild 1x rubber mallet 1x Ausbeulhammer 1x metal denting pin (with 9 change tip) 1x red mini T-bar 1x empty plastic bottle (without adhesive remover) 15x adhesive stickers 54x adhesive adapter 1x carrying bag. Although we did a solid and safe packaging, it may still suffer some damage or missing during transportation, so please check the packing and items before signing your name. The item "PDR Push Rods Tools Kit Car Paintless Dent Removal Repair Puller Lifter Hammer" is in sale since Tuesday, January 19, 2021. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Exterior\Mouldings & Trim". The seller is "dentawaystore" and is located in CA,NJ,KY,NY. This item can be shipped to United States.